Project True 10.5

Several years ago we started dreaming up a third-gen Camaro to compete in the True 10.5 class, a class reserved for both stock suspension and back-halved cars like ours, but one that also requires competitors to retain the factory firewall. Up front, aftermarket suspension is allowed, however it must bolt into the factory location as well. Since then, we ended up purchasing a '91 Z28 that we completely tore apart, and delivered to Bill Hickok of Hickok Race Cars in California City, California, where he's been assembling and fabricating the 25.2 chassis. In past issues, we've shown you the Chris Alston's Chassisworks FAB9 rearend build and install. This time around, we wanted to showcase the basics of a 'cage install with the '63, all the while updating you on the '91 Z28 chassis. We're proud to say that Bill has been keeping his welder busy in order to meet NHRA's strict chassis certification requirements and it's only a matter of time before we get our dedicated track machine onto the tarmac. —Henry D

1. If you're looking to build a third-gen like ours, Chris Alston's Chassisworks offers a complete kit to transform your chassis into a 25.2 roller. Per NHRA requirements, the chrome-moly tubes feature a 15/8-inch diameter and 0.083-inch wall thickness.

2. Compared to the 8.50-certified 'cage, the 25.2 is a lot more elaborate and requires the entire floor to be removed for the lower bars and trans tunnel. This is a single-rail design that'll eventually be covered with aluminum floors; however, we're placing steel floors underneath the driver seat to meet certification requirements. It's also good for wear and tear.

3. Our Chassisworks antiroll bar is a tubular spline piece featuring a 1.25x0.188-inch wall with steel endlink tubes.

4. The lower main crossbar connects the rear four-link.

5. Out back, the rear tree is a critical component to the chassis structure by housing the mounts for the shocks and the antiroll bar, and it also supports the chassis side four-link brackets. This area alone is what can make or break a chassis from being stable on the big end and producing consistent repeatable performance numbers on the track.

SOURCE
Hickok Race cars
California City
CA
760-677-9078
www.hickokracecars.com
Chris Alston's Chassisworks
Sacramento
CA
916-388-0288
www.cachassisworks.com
Chevy 2 Only
PO BOX 985
Mt. Washington
KY  40071
502-239-8487
www.gmclassics.com
Overkill Fabrication
626-589-9924
www.okperformance.com
Harwood
800-222-3392
www.eharwood.com